- Aerodynamic characteristics of a parasol-wing--body combination utilizing favorable lift interference at Mach numbers from 3.00 to 4.63, by Odell A. Morris and Robert J. Mack
- The use of demand-to-capacity indexes for the iterative design of rigid structures for wind, Filmon Habte, Arindam Gan Chowdhury, Sejun Park
- Time-accurate numerical prediction of free flight aerodynamics of a finned projectile, Jubaraj Sahu
- Aerodynamics of a rectangular wing of infinite aspect ratio at high angles of attack and supersonic speeds, by John C. Martin and Frank S. Malvestuto, Jr
- Shock waves and drag in the numerical calculation of isentropic transonic flow, by Joseph L. Steger and Barrett S. Baldwin
- Development of a laser-induced heat flux technique for measurement of convective heat transfer coefficients in a supersonic flowfield, by A. Robert Porro
- Hypersonic aerodynamic characteristics of a model of low-fineness-ratio variable-geometry logistics spacecraft concept, by Bernard Spencer
- Prediction of turbulent diffusing flows using FUN3D, David J. Friedlander, Julianne C. Dudek, and May-Fun Liou
- Exploding wire initiation and electrical operation of a 40-kV system for arc-heated drivers up to 10 feet long, by Robert E. Dannenberg and Anthony F. Silva
- Rotating rig development for droplet deformation/breakup and impact induced by aerodynamic surfaces, A. Feo, M. Vargas, A Sor
- Dynamic modeling of starting aerodynamics and stage matching in an axi-centrifugal compressor, Kevin Wilkes and Walter F. O'Brien, A. Karl Owen
- Aerodynamic characteristics of 24 NACA 16-series airfoils at Mach numbers between 0.3 and 0.8, by W.F. Lindsey, D.B. Stevenson, and Bernard N. Daley
- Numerical method for design of minimum-drag supersonic wing camber with constraints on pitching moment and surface deformation, by Russell B. Sorrells and David S. Miller
- Improvement of aileron effectiveness by the prevention of air leakage through the hinge gap as determined in flight, by H.A. Soulé and W. Gracey
- The effects of Reynolds number, rotor incidence angle and surface roughness on the heat transfer distribution in a large-scale turbine rotor passage, reported by M.F. Blair
- The N.A.C.A. CYH airfoil section, by George J. Higgins
- Design of a slotted, natural-laminar-flow airfoil for business-jet applications, Dan M. Somers
- Dual methods and approximation concepts in structural synthesis, Claude Fleury and Lucien A. Schmit, Jr
- An experimental evaluation of the performance of two combination pitot pressure probes, David J. Arend and John D. Saunders ; prepared for the 47th Aerospace Sciences Meeting sponsored by the American Institute of Aeronautics and Astronautics, Orlando, Florida, January 5-8, 2009
- Note on the air forces on a wing caused by pitching, by Max M. Munk
- An entropy correction method for unsteady full potential flows with strong shocks, Woodrow Wilson, Jr., Mohamed M. Hafez, Stanley J. Osher
- Coupled CFD/GN&C modeling for a smart material canard actuator, Paul Weinacht
- Effect of forebody strakes on the aerodynamic characteristics in pitch and sideslip of a hypersonic airplane configuration at Mach numbers of 1.41, 2.01, and 6.86, by Cornelius Driver
- The compressibility burble, by John Stack
- Computational fluid dynamics (CFD) simulation of hypersonic turbine-based combined-cycle (TBCC) inlet mode transition, John W. Slater and John D. Saunders ; prepared for the 16th International Space Planes and Hypersonic Systems and Technologies Conference cosponsored by the AIAA, DLR, and DGLR, Bremen, Germany, October 19-22, 2009
- Mars pathfinder rarefied aerodynamics, computations and measurements, James N. Moss [and three others]
- FUN3D manual, 13.7, Robert T. Biedron [and sixteen others]
- Pressure distributions on a 0.02-scale space shuttle orbiter nose at Mach 21.5 in helium, George C. Ashby, Peter T. Bernot, and William C. Woods
- Finite element modeling and analysis of Mars entry aeroshell concept, Samee W. Ahmed, Brittney M. Lane
- BANDSLIP advancements, Michael Minnicino
- Rotary balance data for a single-engine agricultural airplane configuration for an angle-of-attack range of 8° to 90°, William Mulcay and Julio Chu
- Gas crossflow effects on airflow through a wire-form transpiration-cooling material, by Albert Kaufman, Louis M. Russell, and David J. Poferl
- Piloted simulation study of an ILS approach of a twin-pusher business/commuter turboprop aircraft configuration, Donald R. Riley and Jay M. Brandon, Louis J. Glaab
- Numerical simulation of pressure-induced separation of turbulent flat-plate boundary layers, definition and overview of new cases with suction-only transpiration and a step in Reynolds Number, Gary Neil Coleman
- Further evaluation of scaling methods for rotorcraft icing, Jen-Ching Tsao, Richard E. Kreeger
- The regional nature of aerodynamic jump, Mark Bundy
- Effect of the surface condition of a wing on the aerodynamic characteristics of an airplane, by S.J. DeFrance
- Water tunnel flow visualization study through poststall of 12 novel planform shapes, Gregory M. Gatlin, Dan H. Neuhart
- Ice accretions and full-scale iced aerodynamic performance data for a two-dimensional NACA 23012 airfoil, Harold E. Addy, Jr. [and six others]
- Low-speed performance of an axisymmetric, mixed-compression, supersonic inlet with auxiliary inlets, Charles J. Trefny and Joseph W. Wasserbauer
- The fairing of airfoil contours, by Edward P. Warner
- Feasibility of electrified propulsion for ultra-efficient commercial aircraft final report, D.K. Hall [and sixteen others]
- Effects of varying the relative vertical position of wing and fuselage, by L. Prandtl
- Determination and classification of the aerodynamic properties of wing sections, by Max M. Munk
- Experimental performance and analysis of 15.04-centimeter-tip-diameter, radial-inflow turbine with work factor of 1.126 and thick blading, Kerry L. McLallin, Jeffrey E. Hass
- Performance of swirl-can turbojet combustors at simulated supersonic combustor-inlet conditions, by Helmut F. Butze, Arthur M. Trout, and Harry M. Moyer
- Horizontal buoyancy in wind tunnels, by A.F. Zahm
- Aerodynamic effects of a split flap on the spinning characteristics of a monoplane model, by M.J. Bamber
- American streamlined design, the world of tomorrow, David A. Hanks and Anne H. Hoy
- Nonlinear aerodynamic modeling from flight data using advanced piloted maneuvers and fuzzy logic, Jay M. Brandon and Eugene A. Morelli