Performance tests
Label
Performance tests
Name
Performance tests
Source
nasat
Focus
Actions
Incoming Resources
- Test hardware design for flightlike operation of Advanced Stirling Convertors (ASC-E3), Salvatore M. Oriti
- Bidirectional brush seals, Robert C. Hendricks [and three others]
- Performance evaluation of a 50 kW Hall thruster, David T. Jacobson, Robert S. Jankovsky
- NASA low-power stirling convertor for small landers, probes, and rovers operating in darkness, Scott D. Wilson [and five others]
- Baseline testing of the EV Global E-Bike, Dennis J. Eichenberg, John S. Kolacz, and Paul F. Tavernelli
- Evaluation of propfan propulsion applied to general aviation, by R.W. Awker
- NASA's Evolutionary Xenon Thruster (NEXT) Prototype Model 1R (PM1R) ion thruster and propellant management system wear test results, Jonathan L. Van Noord and George C. Soulas, James S. Sovey ; prepared for the 31st International Electric Propulsion Conference (IEPC 2009) cosponsored by Aerojet, A.F. Offi ce of Scientifi c Research, AFRL, Busek Company, Inc., CU Aerospace, ERPS, EDA, Inc., L3 Communications, Michigan Space Grant Consortium/NASA, and Michigan Engineering, Ann Arbor, Michigan, September 20-24, 2009
- Performance test results of the NASA-457M v2 Hall thruster, George C. Soulas [and three others]
- Replacement of PBNA in HB and HC polymers used in SRM propellant and liner, prepared by M.L. Levinthal, R.D. Law, D.C. Suisse
- Performance measurement of Advanced Stirling Convertors (ASC-E3), Salvatore M. Oriti
- Five year ground exposure of composite materials used on the Bell model 206L flight service evaluation, Donald J. Baker
- Parametric data from a wind tunnel test on a rocket-based combined-cycle engine inlet, René Fernandez [and three others]
- Development and testing of tip devices for horizontal axis wind turbines, G.W. Gyatt and P.B.S. Lissaman ; prepared for National Aeronautics and Space Administration, Lewis Research Center; for U.S. Department of Energy, Conservation and Renewable Energy, Wind Energy Technology Division
- Flow analysis of the Cleveland clinic centrifugal pump, Joseph P. Veres [and four others]
- Advanced stirling converter (ASC-E2) performance testing at NASA Glenn Research Center, Salvatore Oriti and Scott Wilson
- Mobile router technology development, William D. Ivancic [and five others]
- Dynamic assessment of B-52B-008 carrier aircraft for the revised space shuttle solid rocket booster decelerator subsystem drop test vehicle
- NASA proof-of-concept 1-We stirling converter development for small radioisotope power systems, Nicholas A. Schifer [and three others]
- Optimizing facility configurations and operating conditions for improved performance in the NASA Ames EAST 24 inch shock tube, David W. Bogdanoff and Brett A. Cruden
- Heater validation for the NEXT-C hollow cathodes, Timothy R. Verhey, George C. Soulas, Jonathan A. Mackey
- Programmable, automated transistor test system, Long V. Truong and Gale R. Sundburg
- Tests of the performance of coatings for low ice adhesion, David N. Anderson and Allen D. Reich
- Automated testing experience of the Linear Aerospike SR-71 Experiment (LASRE) controller, Richard R. Larson
- Characterization of partial-gravity analog environments for extravehicular activity suit testing, Jason R. Norcross ... [and others]
- Considerations for the use of remote gaze tracking to assess behavior in flight simulators, Donald J. Kalar [and four others]
- A comparison of flow-through versus non-flow-through proton exchange membrane fuel cell systems for NASA's exploration missions, Mark A. Hoberecht
- Space infrared telescope facility wide field and diffraction limited array camera (IRAC), final report for the period 1September 1984 through 31 October 1987, principal investigator, Dr. Giovanni G. Fazio
- Onsite 40-kilowatt fuel cell power plant manufacturing and field test program, United Technologies Power Systems ; prepared for National Aeronautics and Space Administration, Lewis Research Center; for U.S. Department of Energy, Fossil Energy, Office of Coal Utilization and Extraction
- Testing of densified liquid hydrogen stratification in a scale model propellant tank, John M. Jurns, Thomas M. Tomsik, William D. Greene
- CM-2 environmental/modal testing of Spacehab racks, Mark E. McNelis, Thomas W. Goodnight, Michael A. Farkas
- Glenn Goddard TDRSS waveform 1.1.3 on-orbit performance report, David T. Chelmins
- Topology design and performance analysis of an integrated communication network, Victor O.K. Li ... [and others]
- Refractory metal heat pipe life test, test plan and standard operating procedures, J.J. Martin and R.S. Reid
- AeroMACS system characterization and demonstrations, Robert J. Kerczewski and Rafael D. Apaza, Robert P. Dimond
- Performance characterization of high energy commercial lithium-ion cells, Brianne T. Scheidegger
- Static performance of six innovative thrust reverser concepts for subsonic transport applications, summary of the NASA Langley Innovative Thrust Reverser Test Program, Scott C. Asbury and Jeffrey A. Yetter
- Supplementary report on antilock analyses, J.W. Zellner
- Laboratory model 50 kW hall thruster, David Manzella, Robert Jankovsky, Richard Hofer
- Error control techniques for satellite and space communications, annual status report, Daniel J. Costello, Jr
- Requirements for an advanced ocean radiometer, Gerhard Meister ... [and others]
- Environmental testing of the NEXT PM1 ion engine, John S. Snyder ... [and others] ; prepared for the 43rd Joint Propulsion Conference sponsored by the American Institute of Aeronautics and Astronautics, Cincinnati, Ohio, July 8-11, 2007
- NASA's planned fuel cell development activities for 2009 and beyond in support of the exploration vision, Mark A. Hoberecht
- Validation of high aspect ratio cooling in a 89 kN (20,000 lbf) thrust combustion chamber, Mary F. Wadel and Michael L. Meyer
- Baseline testing of the EV Global E-Bike SX, Dennis J. Eichenberg, John S. Kolacz, and Paul F. Tavernelli
- Liquid oxygen propellant densification production and performance test results with a large-scale flight-weight propellant tank for the X33 RLV, Thomas M. Tomsik and Michael L. Meyer
- Performance evaluation of a high bandwidth liquid fuel modulation valve for active combustion control, Joseph R. Saus [and three others]
- Indium phosphide solar cell research in the United States, comparison with nonphotovoltaic sources, I. Weinberg, C.K. Swartz, and R.E. Hart, Jr
- Performance testing of a high temperature linear alternator for Stirling convertors, Jonathan F. Metscher and Steven M. Geng
- Performance tests of a liquid hydrogen propellant densification ground system for the X33/RLV, Thomas M. Tomsik
- Point-focus concentration compact telescoping array, extreme environments solar power base phase final report, Michael E. McEachen [and four others]
Outgoing Resources
- Focus1